عنوان

CAD Geometry Data Exchange Using STEP :

شابک

364278335X

شابک

9783642783357

شماره

b573811

عنوان اصلي

CAD Geometry Data Exchange Using STEP :

نام عام مواد

[Book]

ساير اطلاعات عنواني

Realisation of Interface Processors

نام نخستين پديدآور

edited by Helmut J. Helpenstein.

محل نشرو پخش و غیره

Berlin, Heidelberg

نام ناشر، پخش کننده و غيره

Springer Berlin Heidelberg

تاریخ نشرو بخش و غیره

1993

نام خاص و کميت اثر

(XIV, 432 pages)

عنوان فروست

Research Reports Esprit, Subseries PDT (Product Data Technology) Project 2195 · CADEX ;, 1.

متن يادداشت

1. Introduction --; 2. Application Protocols and STEP relations --; 2.1 Entity tables and mapping to STEP --; 2.2 Work in the ISO and the concept of Application Protocols --; 2.3 ISO Application Protocols --; 2.4 Other CADEX Application Protocols --; 2.5 Relationships between Application Protocols --; 3. Common Tool Kit --; 3.1 Introduction --; 3.2 The architecture of the CADEX pre- and postprocessors --; 3.3 Technical description --; 3.4 User's Guide --; 4. Development of Processors --; 4.1 Det Norske Veritas Research --; 4.2 DISEL --; 4.3 FEGS Ltd --; 4.4 Gesellschaft für Strukturanalyse --; 4.5 Hewlett-Packard --; 4.6 ISYKON and PROCAD --; 4.7 ITALCAD --; 4.8 Kongsberg 3D Partner A.S --; 4.9 Senter for Industriforskning --; 4.10 Siemens-Nixdorf-Informationssysteme --; 5. Test and Validation --; 5.1 Introduction --; 5.2 User acceptance testing --; 5.3 Conformance testing --; 5.4 The FIAT test library --; 5.5 Test plan and results --; 5.6 Bibliography.

متن يادداشت

With increasing demand for data exchange in computer integrated manufacturing, a neutral connection between dissimilar systems is needed. After a few national and European attempts, a worldwide standardization of product data has been developed. Standard ISO 10303 (STEP - STandard forExchange of Product data) produced in its first version those parts that arerelevant for CAD geometrical data. A European consortium of 14 CAD vendors and users was supported by the ESPRIT programme to influence the emerging standard and implement early applications for it. Over the years 1989-1992, project CADEX (CAD geometry data EXchange) worked out application protocols as a contribution to STEP; developed a software toolkit that reads, writes, and manipulates STEP data; and, based on this toolkit, implemented data exchange processors for ten different CAD and FEA systems. This book reports the work done in project CADEX and describes all its results in detail.

موضوع مستند نشده

Computer science.

موضوع مستند نشده

Database management.

موضوع مستند نشده

Software engineering.

شماره رده

نشانه اثر

مستند نام اشخاص تاييد نشده

edited by Helmut J. Helpenstein.

مستند نام اشخاص تاييد نشده

Helmut J Helpenstein

نام الکترونيکي

نوع ماده

[Book]

تكميل شده

Y