• الرئیسیة
  • البحث المتقدم
  • قائمة المکتبات
  • حول الموقع
  • اتصل بنا
  • نشأة

عنوان
Growth, modeling and device implementation of pulsed laser-deposited thin films

پدید آورنده
M. H. Rahman

موضوع
Applied sciences,Electrical engineering

رده

کتابخانه
کتابخانه مطالعات اسلامی به زبان های اروپایی

محل استقرار
استان: قم ـ شهر: قم

کتابخانه مطالعات اسلامی به زبان های اروپایی

تماس با کتابخانه : 32910706-025

TLpq304487381

انگلیسی

Growth, modeling and device implementation of pulsed laser-deposited thin films
[Thesis]
M. H. Rahman
A. Kumar

University of South Alabama
1998

149

M.S.E.E.
University of South Alabama
1998

The purpose of this research investigation is to fabricate the ferroelectric thin film capacitors by laser ablation and Sol-Gel methods. Barium strontium titanate (Ba{0.5}Sr{0.5}TiO3), lead zirconium titanate (Pb{0.5}Zr{0.5}Ti{0.48}O3), and strontium bismuth tantalate (SrBi2Ta2O9) have been used as ferroelectric materials, and strontium ruthenium oxide (SrRuO3) has been used as top and bottom electrodes. The conducting electrode, strontium ruthenium oxide (SrRuO3), has been chosen as electrode material because of its chemical and mechanical stability and very smooth interface with ferroelectric material. The PZT, SBT, and BST-based capacitors were deposited on different substrates, such as MgO(200), Pt/(100)Si, and r-sapphire. The structural characterizations of the capacitors were examined by x-ray diffraction technique. The electrical characterizations of the capacitors were assessed by the RT66A Standardized Ferroelectric Test System. The PZT capacitors proved to be very reliable in terms of not losing much switched charge after a large number of repetitive polarization reversals (10 cycles) and being able to maintain their charge over long waiting periods (10 seconds) between a write and subsequent read pulse. On the other hand, SBT capacitors have been found to have better long-term properties than PZT capacitors. The BST-based capacitors show reasonable dielectric constants and, thus, have been proven to be very reliable memory devices. The Sol-Gel process has also been used to fabricate PZT capacitors, and the results have been compared to the capacitors made by the PLD method. The capacitors made by Sol-Gel process showed better long-term properties than those made by the PLD process.

Applied sciences
Electrical engineering

A. Kumar
M. H. Rahman

 مطالعه متن کتاب 

p

[Thesis]
276903

a
Y

الاقتراح / اعلان الخلل

تحذیر! دقق في تسجیل المعلومات
ارسال عودة
تتم إدارة هذا الموقع عبر مؤسسة دار الحديث العلمية - الثقافية ومركز البحوث الكمبيوترية للعلوم الإسلامية (نور)
المكتبات هي المسؤولة عن صحة المعلومات كما أن الحقوق المعنوية للمعلومات متعلقة بها
برترین جستجوگر - پنجمین جشنواره رسانه های دیجیتال