عنوان

Structural integrity and failure

161344723X (electronic bk.)

303813614X (electronic bk.)

9781613447239 (electronic bk.)

9783038136149 (electronic bk.)

3037851767

9783037851760

dltt

Structural integrity and failure

[Book]

selected, peer reviewed papers from the International Conference on Structural Integrity and Failure (SIF 2010), July 4-7, 2010, held at the University of Auckland, Auckland, New Zealand /

edited by George Ferguson ... [et al.].

Enfield, NH :

Trans Tech,

c2011.

1 online resource (xii, 260 p.) :

ill.

Advanced materials research,

v. 275.

1022-6680 ;

Includes bibliographical references and index.

Contents note continued: Effects of High Temperature Deformation and Thermal Exposure on Microstructure and Mechanical Properties of Co-Based Superalloy / K.B. Yoo / H.S. Lee / K.S. Song -- Optimum Design for Life Extension on the End Coupling of Aluminum Hot Rolling Process / H.S. Lee / K.B. Yoo / K.S. Song / K.H. Lee -- Integrity Evaluation and Dynamic Behavior of Radioactive Material Transport Cask under Drop Impact / Y.S. Lee / H.S. Lee -- Ab Initio Phonon Dispersion Curves Used to Check Experimentally Determined Elastic Constants of the MAX Phase Ti3SiC2 / Y.S. Lee / H.S. Lee / S.H. Chung -- Failure Mechanisms of Cartilage-on-Bone Tissues and the Influence of Loading History / O. Kirstein / J.F. Zhang / E.H. Kisi / D.P. Riley -- Processing of Layered Hydroxyapatite Ceramic Composites / S. Turley / A. Thambyah / E. Firth / N. Broom -- Nanoindentation of Individual ZnO Nano-/Micro-Rod / R. Sultana / J.Z. Yang / X.Z. Hu --

Contents note continued: Effects of Thermal Exposure on Microstructure and Mechanical Properties of Ni Based Superalloy GTD111 / K. Duan / A.J. McLeod / R.E. Clegg -- Effects of Replication on Measured S-N Curves of Metals / D.S. Kim / J.H. Kim / H.S. Lee / K.B. Yoo -- Fatigue Behavior of Weld-Repaired High Strength Low Alloy Steel / R.E. Clegg / A. Beer / K. Duan -- An Analysis of Fatigue Strength of Notched Components / C.G. Zhang / S. van der Vyver / X.Z. Hu -- Thermal Shock Properties of Ti(Al,O)/Al2O3 and TiAl(O)/Al2O3 Composite Coatings / T. Shingo / K. Yanase / H. Matsunaga / M. Endo -- An Impregnation Technique for Crack Identification Following Uniaxial Tension Tests / A. Salman / B. Gabbitas / D.L. Zhang -- An Analysis of the Bonding Energy through Pull-Out Tests for Aerated Concrete with Various Steel Strip Geometries / D. Alterman / H. Akita / T. Neitzert / J. Alterman --

Contents note continued: Improvement of Biocompatibility of Medical Ni-Ti Alloys through Forming TiO2 Thin Film / K. Kim / Y.S. Kim -- Mechanical Behaviour of Titanium, Ti-6Al-4V (wt %) Alloy and Ti-47Al-2Cr (at %) Alloy Produced Using Powder Compact Forging / Y. Kimura -- Influence of Growth Rate on the Solute Distribution of Directionally Solidified Cu-Ag-Zr Alloy / V.N. Nadakuduru / D.L. Zhang / S. Raynova / P. Cao / B. Gabbitas -- Tensile Properties and Fracture Behaviour of Induction Sintered Ti and Ti-6Al-4V (wt %) Powder Compacts / B.H. Kang / W.H. Lee / K.Y. Kim / H. Cho / J.S. Noh -- Phase Composition, Microstructure and Thermal Diffusivity of Cu/Si Composites Sintering Temperature Dependence / S. Raynova / D.L. Zhang / D. Polo / L. Gonthier / W. Egea / V.N. Nadakuduru -- Tool Wear Mechanisms during Machining of Alloy 625 / H. Cai / Y.P. Wang / X.P. Song / B.J. Ding --

Contents note continued: Low Cycle Fatigue Behavior of Ni-Base Superalloy IN738LC at Elevated Temperature / D. Alterman / J. Vilches / T. Neitzert -- Study of Local Failure of a Multi-Plate Arch Bridge by Numerical Modeling / J.H. Kim / K.T. Hwang / K.B. Yoo / H.S. Lee -- Assembly Deformation and Stresses of Compliant Structures / T. Zhang / X.T. Xu -- Fracture Strengths of Mg Alloy AZ31B-H24 Friction Stir Lap Welds / C.S. Dong / L. Kang -- Effect of Tool Speeds during Friction Stir Lap Welding on Mode of Fracture and Fracture Strength of Al 6060-T5 Joints / Z.W. Chen / S. Yazdanian / G. Littlefair -- Characteristics of Electron Beam Welded Ti & Ti Alloys / S. Yazdanian / Z.W. Chen / G. Littlefair -- Microindentation of Microencapsulated Phase Change Materials / R. Mitchell / A. Short / T. Pasang / G. Littlefair -- Light Emission from a Si Based ZnO Structure / A. Rahman / M. Dickinson / M. Farid --

Contents note continued: Managing Potlife through Statistical Analysis / F. Chen / X.H. Zhan / C.W. Zou / Z. Salcic / W. Gao -- Stress and Vibration Analysis of Motor Back Plate in HDD / P. Lavoie -- Aircraft Joints: the Interaction between Corrosion Protection and Structural Performance / G.S. Heo / O.H. Kang / C.W. Park / S.R. Lee / C.Y. Lee -- Residual Strength Optimisation of a Vent Hole in an Aircraft Component Using a Heuristic Method / G. Clark / U.H. Tiong / A. Jaya -- Influence of Heat Treatment on Fatigue Strength of Drawn Steel Tubes for Small-Sized Single Pass Boiler / R. Das / R. Jones -- The Microstructure and Mechanical Properties of Ni-Based Superalloy after Service Exposure in Gas Turbine / D. Yonekura / Y. Fujie / H. Nishii / H. Yamakawa / R. Murakami -- Degradation Characteristics of Inconel738LC with Thermal Exposure / K.B. Yoo / H.S. Lee / D.S. Kim --

Contents note continued: Microstructure and Mechanical Behaviour of Ultrafine Grained Al-4wt%Cu-(2.5-10) Vol.% SiC Metal Matrix Composites Produced by Powder Compact Forging / L. Fusova / P. Rokicki / Z. Spotz / K. Saksl / C. Siemers -- Effect of Pb and Sn Additions on the Ductility of Cast AZ61 Mg Alloy / A. Gazawi / Zhang / K.L. Pickering / A. Mukhtar -- Cracking and Mechanical Strength of NaOH-Slag Geopolymers / H.M. Liu / W. Gao -- Microstructure Evolution in Nitrogen Implanted Sapphire / B. Zhang -- Fracture Toughness of Polyamide 6/ Maleated Styrene-Ethylene-Butylene-Styrene/Silicon Carbide Nanocomposites / J. Kennedy / J. Leveneur / P. Murmu / A. Markwitz -- Reliability Analysis for Inserts in Sandwich Composites / C.Z. Liao / S.C. Tjong -- Experimental Study on Strengthening of Steel Structures with Fiber Reinforced Plastic / B. Banerjee / B.G. Smith --

Contents note continued: The Influence of Processing Parameters on the Void Content and Compressive Strength of Carbon Fibre-Epoxy Laminates / C.S. Dong -- Strength and Fracture Behavior of Abaca Green Composites / X.W. Yuan / S. Bickerton / S. Bradley / A. Tapiheroe / J. Little -- Microstructure and Hardness of Ni-Cr Porous Preform Reinforced Al-Based Composites by Low Infiltration Method / H. Takagi.

Contents note continued: Validation of BioDent TDI as a New Clinical Diagnostic Method / I. Yan / M. Dickinson / J.P. Schirer / W. Gao -- Effect of Heat Treatment on Microstructure and Mechanical Properties of a Ti-Mo-Zr Alloy / Y.Y. Ding / M. Dickinson / G.A. Williams / K.E. Callon / M. Watson / D. Naot / J.L. Costa / I.R. Reid / J. Cornish -- Copper Coated Iron Powder Prepared by Chemical Reduction Process / X.N. Zhang / P. Cao -- Study of Preparation on the Flake Silver Coating over Copper Powder for Electronic Industry / X.Y. Zhu / Z.C. Guo -- Mechanical Behaviour of Ultrafine Grained Cu and Cu-(2.5 and 5) Vol.%Al2O3 Composites Produced by Powder Compact Forging / X.Y. Zhu / M. Dong -- Friction and Wear Characteristics of SUS304 and SUS630 after Ultrasonic Nanocrystal Surface Modification / A. Mukhtar / D.L. Zhang -- Wear Evaluation of SiCp Reinforced Al Matrix Composites Coatings / Y.S. Pyoun / J.H. Park / C.M. Suh / A. Amanov / J.H. Kim --

Machine generated contents note: An Artificial Neural Network Approach to Fatigue Crack Growth -- Experimental Investigation of PMMA Fracture under Mixed-Modes I, II and III Loading / W.W. Lu / A.K. Hellier / K. Zarrabi -- Modelling Fatigue Crack Growth near an Open Hole under Spectrum Loading Using a New Method for Elastic-Plastic Stress Calculation / A.K. Hellier / K. Zarrabi / A. Karpour -- Effects of Crack Size and Crack Face Interference on Shear Fatigue Crack Growth in a Bearing Steel / C. Wallbrink / W.F. Hu -- A Model for the Cyclic Behaviour of Steel under Earthquake Conditions / K. Yanase / N. Shomura / M. Endo / H. Matsunaga -- Fatigue Strength of Ultrafine Grained Copper Treated by Post-ECAP Mild Annealing / W.G. Ferguson / M.A. Hodgson / C.K. Seal -- Experimental Study on Theory of Critical Distance Applied to the Prediction of Fatigue from Notches / Y. Yokoho / S.Z. Han / N. Kawagoishi / K.J. Euh / M. Goto / K. Nakashima --

0

0

0

0

0

0

0

0

0

Structural integrity and failure.

9783037851760

SIF 2010.

Structural Integrity and Failure.

Building materials-- Testing, Congresses.

Fracture mechanics, Congresses.

Structural engineering, Congresses.

Ferguson, George.

International Conference on Structural Integrity and Failure(2010 :, Auckland, New Zealand)

Knovel (Firm)

20131119112917.0

[Book]

Y